Installation Instructions
Use the threaded holes in the end
cap for mounting the linear actuator.
See if mid-section supports are
needed using the maximum allowable
unsupported length graph on data
sheet.
At least one end cap must be secured
to prevent axial sliding when midsection
support is used.
When the linear actuator is moving
an externally guided load, the clevis
mounting should be used.
Installation Instructions
The linear actuators can be fitted with
the standard carrier mounting facing
in any direction.
To prevent contamination such as
fluid ingress, the actuator should be
fitted with its sealing band facing
downwards.
The inversion mounting can be fitted
to transfer the driving force to the
opposite side
Maintenance
All moving parts are long-term
lubricated for a normal operational
environment. We recommend a check
and lubrication of the linear actuator,
and if necessary a change of the
toothed belt and wear parts, after an
operation time of 12 months of
operation or 3 000 km, depending on
the type of application.
Additional greasing is easily done by
using nipples in the slotted profile.
Please see separate instructions.