ORDER NO. Meas.CFT CODE NO. Inquriy
HV-4 0.3 Inquriy
HV-6 0.4 Inquriy
HV-8 0.8 Inquriy
HV-10 2 Inquriy
HV-12 2.6 Inquriy
HV-14 3.2 Inquriy
HV-16 4.2 Inquriy
VERTEX Horizontal,Vertical Rotary Table,HV-6,8,WITH face plate 1. Our Tables are made of high density Meehanite and use "HEIDENHAIN" electronic e to inspect angle to assure the excellent and durableness.
2. Use excellent machining center to process. Spindle end be applied accuracy bearing. Can be assured to keep very steady under load cutting.
3. Worm is hardened and ground. The ratio is 90:1. The work table is graduateda full 360° so that one turn of the handle moves the table through 4°. Micro collar is graduated in steps of 1'min. And vernier scale makes settings down to 10 seconds possible.
4. These Rotary Tables are popular for their excellent perfor-mance, practical design and reasonable cost. They are widely used for circular cutting work, angle setting, boring, spot-facing and similar work.
5. Using the Key guide block, the center can be corrected and accurately.
ITEM NO. TESTING OBJECTIVE VARIATION(INCHES)(MM) MAXIMUM TESTED
1 FLATNESS OF CLAMPING SURFACE(CONCAVE) .0006(0.015)
2 PARALLELISM OF CLAMPING SURFACE TO BASE .0008(0.0.02)
3 S OF CLAMPING SURFACE TO ANGLE FACE .0008(0.0.02)
4 TRUE RUNNING OF CLAMPING SURFACE .0006(0.015)
5 TURE RUNNING OF CENTER HOLE MEASURED AT HOLE EDGE .0008(0.0.02)
6 INDEXING ACCURACY OF DIRECT INDEXING MECHANISM MAXIMUM CUMULATIVE SPACING ERROR 45"
ORDER NO. Table Base dimension Bolt slots The Load Capacity For Rotary Table Center sleeve Gross Weight kg/lb
Outer diamensions Height
A1 D H H1 A B g Horizontal Vertical
HV-4 70 KGS 18KGS MT-2 (C)7.5
HV-6 78
3.07 150
5.91 80
3.11 100
3.94 200
7.87 160
6.30 15
0.59 40KGS 20KGS MT-2 (C)13
HV-8 100
3.94 200
7.87 105
4.13 135
5.31 265