DPDM‐400 Silicone High Temp Bath Fluid

耐高温导热硅油。SERVICE TEMPERATURE RANGE: 25°C to 250°C open to air / 25°C to 300°C closed to air

AVAILABILITY: 1‐gallon (4kg net wt.), 5‐gallon pail (20kg net wt.), 55‐gallon drum (200kg net wt.)

In comparison to conventional PDMS silicone oils, DPDM‐400 has much higher thermal stability and remains stable at temperatures > 250°C (open system). When heated, its viscosity lowers very which makes it an excellent choice for high temperature laboratory baths and heat transfer systems that have to circulate and pump the fluid. Conversely, it is not recommended for cold temperature systems due to its acute viscosity increase at lower temps.

As a calibration fluid, DPDM‐400 Silicone Fluid is widely used in Flow Control, Temperature Control and Motion Control technologies. Again, its advantage over conventional oils is that it will not break down at high temperatures and it will not coagulate at high pressures. It is widely used for instruments, gauges, sensors, meters and devices that are subject to extreme temperatures and high pressures.

DPDM‐400 Silicone Fluid has a higher RI value (1.505) than conventional PDMS silicone. It an excellent RI index matching fluid and optical fluid for use in sensor /imaging / LED and Photonics technologies that require a higher RI value than conventional fluids.

High Flash Point

High thermal Stability

Viscosity lowers when heated:

Easy to pump/circulate at elevated temps

High Refractive Index RI 1.505

High Dielectric Strength

Hydrophobic

Stable under high rates of pressure

Stable under high rates of shear

Excellent Lubricity

High Temperature Laboratory Bath Fluid

High Temperature Heat Transfer Fluid

High Temperature Dielectric Fluid

High Temp /High Pressure Fluid

High Temperature Fluids for Flow Control Fluid

High Temperature Calibration Fluid

Refractive Index Matching Fluid

High RI Matching Fluids for LED and Optics

High Temp Silicone Lubricants for Plastic Parts

Silicone Lubricants for Rubber Parts