挂历装订机厂家工厂价格报价

  八、可能出现的异常、故障及排除方法 Trouble shooting

8.1台历装订机 挂历装订机 日历装订机 笔记本装订机冲孔系统故障排除 Punching system trouble shooting

   8.1.1   故障现象：机器不动 Symptom: The machine does not move
           产生原因：电源没有接通或者保护开关触发异常。

Cause: The power supply is not turned on or the protection switch is triggered
  排除方法：查看电源开关是否已经接通，保护开关有无异常， 配电箱内空气开关是否断开。

Remedy: Check whether the power switch is switched on, whether the protection switch is abnormal or not, and the air switch in the distribution box is disconnected
8.1.2异常现象：毛边大

Abnormal phenomenon: big hair
  产生原因：纸张太厚，冲针严重磨损

Cause: The paper is too thick and the punch is severely worn
  排除方法：正常运行纸张厚度建议在1-6mm之内；如果是冲针磨损严重请更换。Remedy: normal operation of the paper thickness is recommended within 1-6mm; if the pins wear, please replace.

8.2台历装订机 挂历装订机 日历装订机 笔记本装订机机器手送料系统的故障排除 The feed belt system trouble shooting

   8.2.1 故障现象：机器不动Symptom: The machine does not move
         产生原因：电源没有接通或者光电开关触发异常。Cause: The power supply is not turned on or the photoelectric switch triggers an abnormality
         排除方法：查看电源开关是否已经接通，光电开关有无异常。Remedy: Check whether the power switch is turned on, the photoelectric switch is abnormal.

   8.2.2  异常现象：机械手抓取和送料位置不对             Abnormal phenomenon: the robot grab and feeding position is wrong

   产生原因：皮带拉长松弛或者是皮带固定块1不牢靠。        Cause: The belt is stretched or the belt is fixed

   排除方法：将皮带张紧到合适的松紧度，调整好机械手的位置锁紧皮带固定块。Remedy: Tighten the belt to the appropriate tightness, adjust the position of the robot to lock the belt fixed block.

 

河南省

郑州市　 南阳市　 新乡市　 安阳市　 洛阳市　 信阳市　 平顶山市　 周口市　 商丘市　 开封市　 焦作市　 驻马店市　 濮阳市　 三门峡市　 漯河市　 许昌市　 鹤壁市　 济源市

台历装订机 挂历装订机 日历装订机 笔记本装订机

​