ULTRAMAX蓄电池UL150-12 12V150AH进口

ULTRAMAX蓄电池ULV150AH进口
ULTRAMAX蓄电池ULV150AH进口

ULTRAMAX蓄电池采用低开阀压力设计，使用期间安全阀自动开启闭合，确保使用安全。

ULTRAMAX蓄电池端子：采用电阻极小的嵌入式铜芯端子（端子在电池内的部分包铅），避免端子热膨胀造成密封破坏的问题。ULTRAMAX蓄电池正负极端子有明显标志，便于连接。

ULTRAMAX蓄电池的接线板、连接线均采用导电性能优良的铜材，接线板具有绝缘护套，具有优异的防腐蚀性能。

ULTRAMAX蓄电池采用专用复合式双层微孔隔板，具有优异的机械强度性能，正常使用条件下无内部短路的可能。

封口剂：ULTRAMAX蓄电池槽与盖的之间采用专用热固化型有机硅-丙烯酸-环氧树脂粘接剂进行粘接；ULTRAMAX蓄电池封口剂采用特殊有机硅改性丙烯酸环氧树脂作为基体材料，确保在-40℃～+70℃温度范围内，封口剂保持良好的冲击韧性与密封性能，不会有裂纹与溢流。ULTRAMAX蓄电池壳体承压能力不低于70Kpa。

ULTRAMAX蓄电池常因极板发生膨胀变形而导致电池密封失效及发生泄漏，在ULTRAMAX蓄电池底部专利化设计拱形膨胀式支撑底桥，为极板温度变化以及自然伸长留出自由空间，缓解其对极柱产生的伸长或者缩短的应力，避免出现电池端子的密封出现破坏性泄漏，保证电池的密封性能。

What is the definition of cycle use and standby?

"Cycle Use" - direct power source: This can be used for the charging and discharging of electrical e, which include motorbikes or even the household vacuum cleaner.

"Standby Use" - back up power. Standby use is used as a back-up source of energy. This is mainly used when there is a sudden drop in power or a power cut.

How can you check a battery's performance?

This is dependent upon the battery series; they will require different methods for checking a battery's performance.

Do deep-cycle batteries have a memory?

Unfortunately, deep-cycle battery performance reduces over time. A positive that can be pulled from this is that the deep-cycle batteries do not suffer from any memory problems as NiCd batteries can.

How can I find out the current state of my battery?

Regular battery examinations can interpret irregularities within the batteries themselves but also the charging systems. The method used to examine the electrochemistry of the battery is done through inspection of the electrolytes within the cell. Interpretation can be done through voltage readings.

应用领域：

报警系统；应急照明系统；电子仪器；铁路、船舶、邮电通信；电子系统；太阳能、风能发电系统；大型UPS及计算机备用电源；消防备用电源；锋值负载补偿储能装置。

专业的销售，一流的服务，为您的单位，公司，家庭提供安全可靠的电源解决方案。

本公司代理销售的UPS电源蓄电池保证是原装正品，假一罚十，请广大客户放心购买

阀控式密封铅酸蓄电池常见故障的防范措施


2.1防止VRLA蓄电池鼓肚变形措施

(1)VRLA蓄电池工作环境温度最好在20℃～35℃之间。

(2)25℃环境温度条件下:浮充使用电压为13.5～13.8V,温度补偿系数为-20mV/℃

(3)VRLA蓄电池放电电流最好不要长时间超过400A,整流系统的纹波系数不要大于±0.5%。

(4)VRLA蓄电池安装在通风条件好的地方,电池间必须有20mm以上的间隙。

2.2防止VRLA蓄电池漏液措施

(1)选用优质名牌、技术工艺先进、质保期长的产品,严格验收,签定技术协议。

(2)经常检查电池,对有漏液的电池及时采取措施,如涂凡士林、擦拭等。

(3)加强电池柜架的检查,发现变形及时处理。