48V90A金威源GPE4890A嵌入式通信电源

金威源48V90A嵌入式通信电源GPE4890A 金威源GPE4890A,金威源通信电源,金威源嵌入式电源,48v90A电源高性能高可靠性电源产品

金威源GPE4890A 嵌入式电源系统
输入: 90～280Vac; 输出: -42～-58Vdc；***输出功率：4815W
 

金威源GPE4890A,金威源嵌入式通信电源,金威源48v90A电源GPE4890A嵌入式电源系统 是深圳金威源公司集多年开发和网上运行经验设计的新一代高可靠、高性能的通信电源系统。系统可根据用户需求配置A电源模块，容量满足10～60A。系统采用国际流行的19英寸/2U结构，可以方便嵌入各种通信设备和机柜。系统输入电压范围和工作温度范围极宽，效率高，具有热插拔功能，维护方便快捷。

输入电压: 90～280Vac;
输出电压: -42～-58Vdc；
输出电流：90A
***输出功率：4815W
系统效率：≥91%
工作温度：-20℃～+65℃
尺寸结构：19英寸/2U
系统标准配置：
GPR4830A整流模块3个
GPM48DI监控模块(RS485、TCP/IP接口，LCD)(RS485和TCP/IP接口)
系统配电

应用

■   小型程控交换机

■   接入网

■   传输设备

■   移动通信

■   ***通信地面站

■   微波通信供电

GPE4890A系统电源正常情况下，整流模块、配电单元的各种参数均由监控模块进行控制，按其预定的参数或用户命令进行工作。如果出现市电故障，此时系统将改由电池供电，随着电池的放电，电池端电压开始下降，当电池电压低于46V时，监控模块上报电池欠压信号，当电池电压低于44V时，电池下电。当外部市电***，系统***正常工作状态(以上监控数据为系统默认值，用户可重新设置)。

除电池放电保护外，电池、负载过温保护功能默认情况下是禁止的，用户可以根据需要通过下发命令***或禁止。电源系统的工作环境温度≥55℃，电源系统将需降功率输出。

Jinweiyuan 48v90a embedded communication power gpe4890a

High performance and high reliability power supply products

Jinweiyuan gpe4890a embedded power system

Input: 90 ～ 280VAC; output: - 42 ～ 58vdc; * * * output power: 4815w

Gpe4890a embedded power system is a new generation of high reliable and high performance communication power system designed by Shenzhen jinweiyuan company with years of development and network operation experience. The system can be configured with 10 / 15 / 20 / 30A power module according to the user＇s re, and the capacity can meet 10 ~ 60A. The system adopts the international popular 19 inch / 2U structure, which can be easily embedded in various communication e and cabinets. The system has wide input voltage range and working temperature range, high efficiency, hot plug function, and convenient maintenance.

Input voltage: 90-280vac;

Output voltage: - 42 ~ - 58vdc;

Output current: 90a

***Output power: 4815w

System efficiency: ≥ 91%

Working temperature: - 20 ℃ ~ + 65 ℃

Size structure: 19 inches / 2U

System standard configuration:

Gpr4830a three rectifier modules

Gpm48di monitoring module (RS485, TCP / IP interface, LCD) (RS485 and TCP / IP interface)

System power distribution

application

■ small SPC exchange

■ access network

■ transmission e

■ mobile communication

■ * * * communication ground station

■ microwave communication power supply

Under the normal power supply of gpe4890a system, various parameters of rectifier module and power distribution unit are controlled by monitoring module, and work according to their predetermined parameters or user commands. In case of mains failure, the system will be powered by the battery at this time. As the battery discharges, the battery terminal voltage begins to drop. When the battery voltage is lower than 46v, the monitoring module reports the battery undervoltage signal. When the battery voltage is lower than 44V, the battery will be powered off. When the external power supply is on, the system is working normally (the above monitoring data is the default value of the system, which can be reset by the user).

In addition to the battery discharge protection, the battery and load over temperature protection functions are prohibited by default, and users can issue a command * * * or prohibit as needed. The working environment temperature of the power supply system shall be ≥ 55 ℃, and the power output of the power supply system shall be reduced.