民用线押出机日常保养是延长设备的使用寿命，减少设备故障的有效方式。电源线押出机的保养要点如下：
1.押出机使用二个月后，要更换减速机的齿轮油，去除磨合期产生的残杂物。后续定期检查油位，补充加油。
2.各转动部件的轴承位，要定期加油，增强润滑减少磨损。
3.定期检查各部件的螺丝、螺母、电器线路的插头、固定螺丝有无松动、脱落。
4.定期检查各部件，有无异常噪音，传动轮和皮带的磨损及松紧状况。
5.保持配电器、电箱内洁净，干燥、不得有杂物、水及其他金属物品在内，以免造短路烧掉电器。
Daily maintenance of the power cord extruder is an effective way to extend the life of the e and reduce e failure. The maintenance points of the power cord extruder are as follows:
1. After using the extruder for two months, replace the gear oil of the reducer to remove the residuals generated during the running-in period. Regularly check the oil level and refuel.
2. The bearing position of each rotating component should be refueled regularly to enhance lubrication and reduce wear.
3. Regularly check the screws, nuts, electrical circuit plugs, and fixing screws of each component for looseness or falling off.
4. Regularly inspect each component for abnormal noise, wear and tightness of the drive wheel and belt.
5. Keep the distributor and electric box clean, dry, and free of debris, water and other metal objects, so as to avoid short circuit burning of electrical appliances.