450/750V阻燃聚氯乙烯\交联聚乙烯绝缘耐火控制电缆PVC(XLPE)InsulatedFire-ResistantPowerCable产品标准本产品按GB12706《额定电压35kV及以下铜芯、铝芯塑料绝缘控制电缆》和GB12666《电线电缆燃烧实验方法》标准生产,同时还可根据用户需要按国际电。

Conditions of use: cable using the environment temperature is to 40 ℃ ~ + 50; At 25 ℃ when the humidity is 95%; Cable laying temperature - 10 ℃ or higher; When laying the cable, the bending radius MHYV is 10 times of the cable outer diameter or 15 times of the cable outer diameter
电缆规格如下:表2型号额定电压(U0/U)对数标称截面(m㎡)DJYVPDJYPVDJYPVPDJYVRPDJYPVRDJYPVPRDJYVP22DJYPV22DJYPVP22450/7501,2,3,4,5,6,7,8,10,12,14,16,19,240.75,1.0,1.5技术要求。
电缆导体的长期工作温度应不超过70℃。铝护套电缆具有良好的屏蔽性能,综合护层有一定的屏蔽性能,可用于铁路电气化区段的干线或强电干扰地区。电缆的弯曲半径不小于外径的15-20倍。5.信号电缆规格标准有:4、6、8、9、12、14、16、19、21、24、28、30、33、37、42、44、48、52、56、61。

自承式电缆结构:导线:退火裸铜线,铜线直径为0.32,0.4,0.5,0.6,0.7,0.8,0.9mm。绝缘材料:高密度聚乙烯或乙/丙共聚物,绝缘现的颜色符合全色谱标准。绝缘线对:二根不同颜色的绝缘线按不同的节距扭绞成对,采用规定的 HYAC-索道通信电缆-的详细介绍色谱组合以便识别。
以十分低的频率f1起动电机,然后加速达到频率f2,此时负载还包括转子惯量J,此为加速惯量,需要必要的惯量加速转矩Tα,因此这两个转矩(TL+Tα)的合成转矩成为起动到转速频率f2时所必须的转矩。此时的加速转矩为下面步进电机运动方式的第一项:上式的D为速度比例系数,第二项因此比其他项小而忽略不计。TM为步进电机产生的电磁转矩,(TM-TL)如图上图所示,能产生加速度的转矩。速度到达f2后按设定的转速旋转一段时间,然后减速到f1,形成速度包络线,此时的减速运转称为减速驱动,此种速度曲线称为梯形驱动。
The cross section of the control cable is generally no more than 10 square meters, and the power cable is mainly used to transport power, which is generally large. Due to the above all when it comes to the reason, the specifications of the power cable can generally larger, to 500 square feet (normal manufacturer can produce range), again big cross section of the general factory is relatively less, you can do and control cable section generally small, generally not more than 10 largest square, tell from some cable, power cable according to the request of power grid, most commonly for five core, and control cable transmission control signal, some more, according to the standard terms of more than 61 core, but also can produce according to user requirements.
我公司生产的以下型号矿缆获得煤矿矿用产品安全标志证书: MHJYV(1、2)×2;MHYAV(20、30、50)×2;MHYV(1、2、5)×2; MHYA32(30、50、80)×2;MHYBV20×2; 我公司生产的以下型号矿缆获得煤矿工业安全标志准用证: MHYVRP1。
MVV聚氯乙烯绝缘聚氯乙烯护套矿用电力电缆用途:矿井中电能传输线路,但不能承受机械外力作用MVV22煤矿用聚氯乙烯绝缘钢带铠装聚氯乙烯护套电力电缆用途:矿井中电能传输线路,能承受一定机械外力MVV32煤矿用聚氯乙烯绝缘细钢丝铠装聚氯乙烯护套电力电缆用途:矿井中电能传输线路,能承受一定的拉力MVV42。
???? In flame retardant series products, has been successfully used in the oxygen isolation technology, not only 0.6/1 kv polyvinyl chloride insulated and crosslinked polyethylene insulation flame retardant power cable can achieve GB/T12666.5 "into A bunch of power cable test" in class A, and rated voltage up to and including 6/10 kv 8.7/15 kv crosslinked poly (flame retardant power cable can reach A high class A demand and A large margin. On the basis of high flame retardant and high flame retardant cross-linked insulation, a low-smoke halogen-free high-flame retardant oxygen insulation layer power cable was added, and its low-smoke halogen-free performance was in line with GB/T17651.1.2 and GB/ t1765650.1.2. In this way, the overall level of the company's cross-linked power cable is lower than the domestic status. This company produces the type refractory power cables for rated voltage 0.6/1 kv copper core cable, can also produce low smoke zero halogen fire-resistant power cable, high flame retardant fire-resistant power cable oxygen insulation layer, the fire-resistant performance in line with the GB/T12666.6 cable fire resistance test. Therefore, the overall performance of refractory series power cables is good and reliable. The water resistance performance of fireproof cable conforms to iec 502-2.

在缆芯中和屏蔽层的内外表面用石油膏填充或浇注处理,以防止煤矿中水分侵入。在煤矿常见的30~C一60~C的环境条件下,煤矿用通信电缆的机械和电气性能保持不变。用于平巷、斜巷及机电硐室做通信线以及用于平巷,竖井或斜井作主信号传输。
带钢丝绳PVC弹性体行车控制电缆,具有柔软、耐磨、防油等特性,线旁附钢丝绳,增强抗拉力。适用于交流额定电压0.6/1KV及以下的行车、台车、传输机械等移动电器用动力传输线及控制、照明、通讯线路,本产品已广泛应用于冶金、电力、船舶、港口等行业。
另外,读卡器是一种长时间使用的设备,电路设计中一定要有防死机的电路进行保护,这点也是要注意的。注意事项四:是选用封胶的还是不封胶的读卡器?建议选用不封胶的读卡器,理由是:即使封胶了,蜂鸣器还是裸露在外面的,这里进水也会损坏读卡器。封胶采用的材料是树脂类的,国内一般都采用手工封胶固化剂混和不均匀,国内的树脂材料价格便宜但质量不好,长时间使用后会有导电性,使得读卡器运行混乱或者死机,进口树脂价格昂贵国内厂家一般不愿意采用,平摊到每个读卡器要十几块成本,此外,封胶也不适合设备散热,对读卡器的性能也是有影响的,所以,除非特殊场合一般没有必要一定要采用封胶的读卡器,特殊场合对读卡器进行一些防水保护就可以了。
MHY32煤矿用聚乙烯绝缘钢丝铠装聚氯乙烯护套通信电缆用于平巷、竖井或斜井作主信号传输。KVVP型、ZR-KVVP型450/750V铜芯聚氯乙烯绝缘聚氯乙烯护套编织屏蔽控制电缆 。 KVVP2型、ZR-KVVP2型450/750V铜芯聚氯乙烯绝缘聚氯乙烯护套铜带屏蔽控制电缆 。

ZR-BPYJVP3交联聚乙烯绝缘聚氯乙烯护套铝聚酯复合膜绕包屏蔽变频电力电缆。阻燃电缆:由于电缆线路起火带来的危害,促使****都把电缆的阻燃性放到日益重要的位置上,我公司生产阻燃电缆见表1-2。适用于交流额定电压U0/U=450/750V供电,监控等回路中。
6KV及以上电缆接头: ①安装电缆终端头时,必须剥除半导体电屏蔽层,操作时不得损伤绝缘,应避免刀痕凹凸不平的情况,必要时用砂纸磨平;屏蔽端部应平整,并要把石墨层(碳粒)清除干净。 ②塑料绝缘电缆端头铜带屏蔽和钢铠必须良好接地,对短路也遵循这项原则,避免三相不平衡运行时钢铠端部产生感应电动势,甚至“打火”及燃烧护套等事故。
kvv 2芯*0.75控制电缆 kvv 2芯*1.0控制电缆 kvv 2芯*1.5控制电缆 kvv 3芯*0.75控制电缆 kvv 4芯*0.75控制电缆 kvv 5芯*0.75控制电缆 kvv 6芯*0.75控制电缆 kvv 7芯*0.75控制电缆 kvv 8芯*0.75控制电缆 kvv 10芯。