新闻资讯

PTY23铁路信号电缆4X1成武供应商KVVP8X1.0屏蔽8芯控制电缆苗条

发布时间:2025-08-24 03:02  点击:1次
PTY23铁路信号电缆4X1成武供应商KVVP8X1.0屏蔽8芯控制电缆苗条

  IEC/BS4066-1阻燃等级(单根电线或电缆垂直燃烧测试FlameTestONSingleVerticalInsulatedWires/Cables)这是单根电缆的阻燃标准。IEC/BS4066-3阻燃等级(成束电线或电缆垂直燃烧测试FlameTestOnBunchedWires/Cables)这是成束电缆的阻燃标准。

PTY23铁路信号电缆4X1成武供应商KVVP8X1.0屏蔽8芯控制电缆苗条

BJYC3V32 / SA communications twisted-pair (aluminous model with shielding. Steel wire armoured cable. Flame retardant) call communication cable is for GTC and STENTOFON communication system in order not to wake the set of a small section multi-fiber process USES communication cable, with reference to foreign / 60029 series of products in the structure, with high temperature resistant DJFP2FP2 computer cable, DJFFP2, DJFP2V, DJFP2VP2, DJFVP2, high temperature resistant computer cable - type: DJFFP,DJFPF,DJFPFP,DJFPFP, DJFFP, DJFPV,DJFP.

  二、产品执行标准GB三、使用特性1、交流额定电压:U0/U450/750V;2、最高工作温度:阻燃聚氯乙烯绝缘和护套70℃和105℃;氟塑料绝缘和护套200℃和260℃;交联聚乙烯绝缘90℃;低烟无卤阻燃聚烯烃70℃;低烟无卤阻燃交联聚烯烃90℃和125℃。

  电缆额定电压的选择●电缆的额定电压应适合于电缆系统的运行状况,用Uo/U(Um)KV表示。Uo--电缆设计用的导体对地或金属屏蔽之间的额定工频电压;U--电缆设计用的导体间的额定工频电压;Um--设备可承受的“最高系统电压”的最大值。

PTY23铁路信号电缆4X1成武供应商KVVP8X1.0屏蔽8芯控制电缆苗条

The total shielding structure can adopt copper wire and copper band combination shielding, copper wire braid shielding, copper wire braid shielding, copper wire braid shielding, etc. The shielded cable of this structure can resist electromagnetic induction, poor grounding and power line, reduce inductance and prevent the induction electromotive force from being too large.

其中常用的七脚管有6A6K6J6J6G6Z4等;常用的九脚管有6P6N6P16U6E6E2,由于这两类管子都属于玻璃外壳的小型管子,也称为指形管或花生管,而把它们的管脚称为小七脚、小九脚。这些管子的管脚朝向自己,有两只管脚之间的距离较大,我们称这段较大距离为缺口,把缺口左边第一只管脚数为第一脚,然后按顺时针方向依次为第第..。如上图典型的双三脚管管脚图。八脚管,如6P6P、6J8P、5Z3P等,这些管子的管脚之间的距离是相等的,为了防止插错又设了一个中心管钥其定位作用,管钥左边第一个管脚为第一脚,然后顺时针方向依次为第二脚....如上图所示。

  6、使用特性:电缆导体的长期允许工作温度为70℃,电缆敷设温度应不低于0℃。电缆允许的弯曲半径:对有铠装或铜带屏蔽结构的电缆应不小于电缆外径的12倍。对有屏蔽层结构的软电缆,应不小于电缆外径的6倍。对无铠装层的电缆应不小于电缆外径的6倍。

  产品标准:GB使用条件:电缆导休的长期允许工作温度为70℃;无铠装层的屏蔽电缆,应不小于电缆外径的6倍;有铠装或铜带屏蔽结构的屏蔽电缆,应不小于电缆外径的12倍;有屏蔽层结构的软屏蔽电缆,应小于电缆外径6倍。
1. Product implementation standard: gb9330-88 (refer to IEC227, better voltage resistance than IEC227), ga306-2001 (flame retardant type). 2. Purpose: this product is applicable to control, signal protection and measuring lines with rated voltage of 450/750v and below under dc and ac 50hz-60hz. 3, product specifications and scope: product specifications range using occasions KYV, KYVP, KYVP2 0.5 - was 10, 2-61 core is the product high insulation resistance, waterproof properties is strong, good cold resistance, suitable for weak current control system or strong electromagnetic interference zone. KYV20,KYV22 0.5-10mm2,4-61 core FYV30,KYV32 0.5-10mm2,7-61 core KYVR 0.5-6mm2,2-61 core KYVRP 0.5-4mm2,2-61 core KYVP22, kyvp2-22 1.5-10mm2,4-61 core note: model pre-flame retardant is suitable for fire retardant environment. 4, using features: cable temperature under installation should not below 0 ℃, the cable conductor long-term allowed working temperature is 70 ℃. The allowable bending radius of the cable: for the armored cable, it should not be less than 6 times the outer diameter of the cable. For the cable with armored or copper belt shielding structure, it shall be no less than 12 times the outer diameter of the cable. For soft cable with shield layer structure, it should be no less than 6 times the outer diameter of the cable.
PTY23铁路信号电缆4X1成武供应商KVVP8X1.0屏蔽8芯控制电缆苗条

  2.3 电缆的基本型式、产品名称和适用范围: 表1型式代号名 称适用范围ZA-RV铜芯阻燃聚氯乙烯绝缘软电缆架空、管道、室内、电缆沟、地下直埋ZA-RVV铜芯阻燃聚氯乙烯绝缘聚氯乙烯护套软电缆ZA-RVV22铜芯阻燃聚氯乙烯绝缘钢带铠装聚氯乙烯护套软电缆WDZA。

Sheathed control cable products use feature: the cable conductor of long term working temperature should be allowed no more than 70 ℃. When the cable temperature under installation should not below 0 ℃, when laying bending radius should not less than 10 times of cable diameter. The cable with armor layer or copper band shielding structure shall not be less than 12 times the outer diameter of the cable.

  3、产品标准:GB9330.2-88《聚氯乙烯绝缘和护套控制电缆》4、电缆型号、名称及使用范围型号名称使用范围ZR-KVV阻燃聚氯乙烯绝缘,阻燃聚氯乙烯护套控制电缆敷设在室内、电缆沟中、管道内及地下。

下图中红色框中的选项一定要勾上,否则会出现变量只能读取不能写入的现象。注意本站号:当打开时是10进制,这里必须把10进制转化成16进制,以方便组态王中使用。使用外置以太网模块第一个步骤同使用内置以太网模块,本例以外置三菱以太网模块QJ17E71-100为例;设置“网络参数”点击“MELSECNET/以太网”配置外置以太网模块可按照实际情况选择上图中的“网络类型”,“起始I/O号”,“网络号”,“组号”,“站号”,并选择对应“模式”。

  ZR-FV、ZR-KFF、KFFP、KFFP2、FV22 KFFR、KFFRP、KFFRP2、DJFPFP、DJFPFPR具体的型号有:ZR-KHF4、ZR-KHF4R、ZR-KHF4P、ZR-KHF4RP、KHF4、KHF4R、KHF4PR、KHF4P、KHF4RP、ZRC-KHF4、ZR-K。

  可采用任何一种方式敷设,更适于岩石地区的敷设。HYAT23铠装通信电缆用途:铠装通信电缆机械保护层可以加到任何结构的电缆上,以增加电缆的机械强度,提高防侵蚀能力,是为易受机械破坏及易受侵蚀的地区而设计的电话电缆。

PTY23铁路信号电缆4X1成武供应商KVVP8X1.0屏蔽8芯控制电缆苗条

  技术要求导体20℃直流电阻应符合GB9330.1的规定绝缘电阻见表3-表6要求。电缆阻燃性能试验符合GB/T18380的规定,如用户不要求按C类阻燃要求。电缆烟浓度应符合GB/T17651的规定,其最小透光率为60%。

  CABLE●用于工业环境下各种电气安装,连接、电源、控制、信号等●国标RVVSP电缆●抗电磁干扰屏蔽●信号传输稳定●两两绞合短节距对绞线芯产品特性:整体机械性能优异、信号传输稳定、有一定的柔软性、耐潮、耐寒性、能承受一定的机械应力,使用安全。

天津市电缆总厂第一分厂市场部

总经理:
王艳(女士)
电话:
0316-5961400
手机:
15075619608
地址:
河北省廊坊市大城县毕演马工业园
邮件:
1062174610@qq.com
我们发布的其他新闻 更多
kvvp8x1新闻
拨打电话
微信咨询
请卖家联系我