2．最低环境温度：固定敷设-40℃非固定敷设-15℃。3．额定电压U0/U450/7504．最小弯曲半径：无铠装层电缆应不小于电缆外径的6倍，带铠装层电缆应不小于电缆外径的12倍。绝缘性能要求绝缘线芯应能经受GB/T3048.9规定的交流50Hz火花试验作为中间检查。
一、产品简介动力电缆用输配电系统，本公司生产的交流额定电压0.6/1KV聚氯乙烯绝缘动力电缆和35KV及以下交联聚乙烯动力电缆，其性能不仅符合标准GB1276和IEC60502及IEC60840，并且已形成系列，即阻燃型的、耐火型的、耐寒型的和防水型的动力电缆。
Armored communication cable structure: 1. Basic cable: any filled and unfilled cable with single sheath or double sheath structure. 2. Armored communication cable mechanical protection layer: type 53 adopts 0.15mm thick corrugated steel belt, which is longitudinal wrapped on the basic cable and overlapped on both sides. The surface of the steel belt is coated with plastic to prevent corrosion and water intrusion. The type 23,22 has similar performance with double steel band wrapping. 3. Armored communication cable sheath: black high-molecular weight low-density polyethylene or polyvinyl chloride thin sheath. Sheath thickness may depend on the basic cable outer diameter. 4, identification and marking: cable appearance with permanent identification mark, tag, at no more than alternate 1 m intervals between 5, sheathed communication cable tag contents are: the diameter of wire, wire on the quantity, type of cable, length, factory name and year of manufacture. 6. Armored communication cable electrical characteristics: the cable meets all the electrical requirements of the basic cable. 7. Cable length: mechanically protected cable is manufactured according to the standard length of the corresponding basic cable
Features: rated voltage UO/U is 300/500v. Allowed working temperature does not exceed 70 ℃, laying temperature not lower than 0 ℃, allowed bending radius should not less than 12 times of cable outer structure of soft cable should be no less than eight times outside the cable, copper tape screened cable shall be less than 15 times of cable diameter.
根据双方协商规定的长度交货。适用于交流额定电压250V或直流500V及以下铁路信号联锁、火警信号等各类电器仪表及自动装置的连接线。目前大量使用于智能电表集中抄表信号传输。RS232/RS-485通讯电缆信号线适用于EIARS-232/422通讯网络，是楼宇自控、工业控制网络、电力自动化等通讯网络的常用电缆型号。
使能断开，计数器停止计数，计数器位仍为1，使能位再为1时，计数器在原来的计数基础上计数。以上三种计数器可以通过复位指令复位。正交计数器A相超前B相90度，增计数B相超前A相90度，减计数当要改变计数方向时（增计数或减计数），只要A相和B相的接线交换一下就可以了。译码指令和编码指令：译码指令和编码指令执行结果DECO是将VW2000的第十位置零（为十进制的1024），ENCO输入IN最低位为1的是第3位，把3写入VB10（二进制11）。
销售生产各类煤矿用阻燃通信电缆|煤矿用阻燃通讯电缆|煤矿用阻燃控制电缆|煤矿用信号电缆|矿用通信电缆|矿用通讯电缆|矿用控制电缆|矿用信号电缆|矿用电缆|信号电缆|通讯电缆|通信电缆|煤矿用电缆|市内通信电缆|屏蔽信号电缆|屏蔽控制电缆|铠装通信电缆|充油通信电缆|计算机屏蔽电缆|计算机电缆|煤矿。
Flame-retardant cables are characterized by a delay in the spread of flame along the cable so that the fire does not expand. Because of its low cost, it is a kind of cable widely used in fireproof cable. Under the condition of single cable or into a bunch of laying, cable to know when the spread of flame can be controlled within a certain range, so it can avoid fire spreading combustion and lining major disasters, which cable line of fire prevention level.
2.电缆敷设安装允许弯曲半径：非铠装层电缆应不小于电缆外径的6倍；铠装或屏蔽层结构电缆应不小于电缆外径的12倍；屏蔽层结构的软电缆应不小于电缆外径的6倍。电缆地线芯绝缘采用具有抗氧化性能的K型B类低密度聚乙烯。
MHVV32-4（4×1.5）矿用阻燃组合通信电缆用于煤矿竖井或斜井作通信线。MHPVP3V32-7（2×2×0.5＋1×0.5＋2×6.0）煤矿用阻燃组合通信电缆用于煤矿竖井或斜井作通信线。MHYVRPZ矿用聚乙烯绝缘铝/塑复合带屏蔽编织铠装聚氯乙烯护套通信软电缆用于斜井和平巷作通信线。
矿用控制电缆用途：执行企标标准Q/TX，本标准适用于煤矿用铜芯聚氯乙烯护套阻燃控制电缆。6、有屏蔽结构的软电缆，应不小于电缆外径的6倍。矿用通信电缆用途：实心绝缘填充型电缆适用于煤矿管网的管道铺设，主要用于管道敷设。
Spin cassette XF5-273 communication cable transfer box, adopting advanced technology at home and abroad, in accordance with the international advanced standard production in the eighty s of cable wiring equipment, for the city, the town of telecommunication network backbone cable and wiring cable transfer. Features: 1. The connection jumper adopts rotary clamp-type connection and is sealed with silica gel on the metal clip, because it is not only reliable and durable, but also easy to operate and repair without stripping. 2. The wiring terminals in the handover box shall be arranged in 25 pairs as a basic unit, consistent with the basic units of the local telephone cables and marked with Numbers on the terminals to facilitate construction and maintenance. 3. The structure, arrangement and installation dimensions of the wiring modules are exactly the same as those of 3M products and can be used for each other. 4. The box body is treated by electrostatic spraying, beautiful and generous, with clear lines, good anti-corrosion and waterproof performance and long service life. Main technical parameters: the environment temperature: - 40 ℃ ~ + 65 ℃ atmospheric pressure: 70 ~ 106 kpa relative humidity: 95% or less is random ends and insulation resistance between terminals and ground > 5 x 104 Μ Ω. When connecting any two ends and any terminals and grounding to 1000V ac, there shall be no breakdown or flying arc in 1min. Contact resistance between wire and terminal < 5 x lO - 3 Ω.
定时器采用断电延时定时器，控制程序如所示。FC1控制程序编辑共享数据块。共享数据块DB3可为FB10保存发动机（汽油机和柴油机）的实际转速，当发动机转速都达到预设速度时，还可以保存该状态的标志数据。DB3的数据如所示。编辑功能块。在该系统的程序结构内，有2个功能块：FB1和FB10。FB1为底层功能块，所以应首先创建并编辑；FB10为上层功能块，可以调用FB1。编辑底层功能块FB1。在项目内创建FB1，符号名“Engine”。
对电缆端头和中间接头的基本要求：a.导体连接好；b.绝缘可靠，推荐采用辐照交联热收缩型硅橡胶绝缘材料；c.密封良好；d.足够的机械强度，能适应各种运行条件。 电缆端头必须使用防止水及其它腐蚀性材料的侵蚀，以防因水树引起绝缘层老化而导致击穿。
二、市话缆用途HYA型、HYAT型、HYAC型、HYPAT型、HYPA型和HYA53型HYAT53型、HYPA53型、HYPAT53型电缆是为电话交换区、中继干线而设计的电话电缆，HYA、HYAT、HYPA和HYPAT主要用于管道铺设，也可用于架空，但需要吊线；HYAC只适用于架空，无需用吊线或挂钩。
Dc resistance: 20 ℃ and 0.4 mm copper wire, less than or equal to 148 Ω/km, 0.5 mm copper wire, less than or equal to 95 Ω/km.
射频电缆按绝缘型式分类（1）实体绝缘电缆在这种电缆的内外导体之间全部填满实体高频电介质，大多数软同轴射频电缆都是采用这种绝缘型式。（2）空气绝缘电缆电缆的绝缘层中，除了支撑内外导体的一部分固体介质外，其余大部分体积均是空气。