电力铁路专用电缆1、产品执行标准：GB参照采用IEC227。耐电压优于IEC227），GA阻燃型）。销售生产各类煤矿用阻燃通信电缆、煤矿用阻燃信号电缆、矿用阻燃控制电缆，煤矿用阻燃通讯电缆、矿用电缆、矿用通信电缆、矿用信号电缆、矿用通讯电缆、，矿用控制电缆，监控电缆、传感器电缆、煤矿用电缆，煤矿电缆，煤矿用通信电缆，煤矿用控制电缆。矿用阻燃电缆。信号电缆、本安防爆电缆、控制电缆、计 机电，DJYVP3，HYAT：铜芯实心聚烯烃绝缘填充式挡潮层聚乙烯护套市内通信电缆，HYAC：铜芯实心聚烯烃绝缘自承式挡潮层聚乙烯护套市内通信电缆。
配线电缆主要用于市内电话电缆至分线箱或配线架之用。铜芯聚乙烯绝缘市内话缆●用途：产品用于市内、郊区或城镇地区的电信线路中，作通信干线或中继线。电缆导体的最高额定温度为90℃；短路时电缆导体的最温度不超过250℃。
Identification and length marking: there is a sexual identification mark on the cable appearance, and the marking interval is not more than 1m.
YVVYVVPRVVRVVP仪表用电缆1、产品用途：本产品适用于仪表、仪器及其它电器设备中的信号传输及控制线路，阻燃音频电缆；ZC-HYA、ZC-HYAC、ZC-HYAT、ZC- HYA53、ZC-HYAT53、ZC-HYV、ZC-HYA23、ZC- HYAT23、ZC-HYA22、ZC-HYAT22 产品说明：本厂生产市内通信电缆适用于固定敷设架空或地埋 ZR-HYA：铜芯实心聚烯烃绝缘挡潮层阻燃聚乙烯护套市内通信电缆 ZC-HYAT：铜芯实心聚烯烃绝缘填充式挡潮层阻燃聚乙烯护套市内通信电缆 ZC-缘挡潮层聚乙烯护套钢塑带铠装阻燃聚乙烯护套市。
其低烟无卤性能符合 标准GB/T和12。6KV及以上电缆接头：①安装电缆终端头时，必须剥除半导体电 层，操作时不得损伤绝缘，应避免刀痕凹凸不平的情况，必要时用砂纸磨平； 端部应平整，并要把石墨层（碳粒）清除干净，对短路也遵循这项原则。避免三相不平衡运行时钢铠端部产生感应电动势，甚至“打火”及燃烧护套等事故，电缆敷设安装允许弯曲半径应不小于电缆外径的12倍，ia-K2YV本安型PE绝级、PVC护套二芯绞合 控制电缆固定敷设在室内、电缆沟或管道中，YV铠装通信电缆HYV22通信电缆HPVV铠装通信电缆HPVV22室内通信电缆HJVV 通信电缆HJVVP系列三类大对数语音通信电缆计 机电缆系列本安计 机电缆计 机电缆DJYVP2计 机电缆DJYP2V计 机电缆DJYP2VP2计 机电。
不仅的聚 乙烯绝缘和交联聚乙烯绝缘阻燃动力电缆能达到GB/T126665《成束动力电缆燃烧试验方法》中A类，而且额定电压6/10KV及交联聚乙烯阻动力电缆也能达到A类高阻燃要求且有较大裕度，3、电子计 机电缆型号及使用范围：产品型号规格范围使用场合JVVJVVRJYVJYVRJYJVJYJVRJVPVJVVPJYVPJYJVPJVVPRJYVPRJYJVPRJVVP2JVVP2RJVVP3JVVP3R21-100对（3线组）用于一般工，产品介绍-矿用控制电缆MKVV矿用控制电缆，我公司生产的矿用通信电缆、矿用信号电缆。
适用于工矿企业、能源交通部门、供交 额定电压450/750伏以下控制、保护线路等场合使用的聚 乙烯绝缘、聚 乙烯护套控制电缆。本厂生产的控制电缆经 检测合格，检测内容如下：额定电压：U0/U为450/750V。DJYJV(R)P22交联聚乙烯绝缘铜丝编织总屏聚 乙烯护套钢带铠装计 机用 (软)电缆。DJYJPV(R)22交联聚乙烯绝缘铜丝编织分屏聚 乙烯护套钢带铠装计 机用 (软)电缆，DJYJPV(R)P22交联聚乙烯绝缘铜丝编织分屏总屏聚 乙烯护套钢带铠装计 机用 (软)电缆，符合MT818煤矿用阻燃电缆及MT386所要求的阻燃性能。
阻燃音频电缆；ZR-HYA、ZR-HYAC、ZR-HYAT、ZR- HYA53、ZR-HYAT53、ZR-HYV、ZR-HYA23、ZR- HYAT23、ZR-HYA22、ZR-HYAT22 产品说明：本厂生产市内通信电缆适用于固定敷设架空或地埋 ZR-HYA：铜芯实心聚烯烃绝缘挡潮层阻燃聚乙烯护套市内通信电缆 ZR-HYAT：铜芯实心聚烯烃绝缘填充式挡潮层阻燃聚乙烯护套市内通信电缆 ZR-HYAC：铜芯实心聚烯烃绝缘自承式挡潮层阻燃聚乙烯护套市内通信电缆 ZR-HYA53：铜芯实心聚烯烃绝缘挡潮层聚乙烯护套钢塑带铠装阻燃聚乙烯护套市内通信电缆。
1. Wire: annealed bare copper wire with a diameter of 0. 30, 0. 42, 0. 52, 0. 60, 0. 70, 0. 80, 0. 90 (mm). 2. Insulation material: high density polypropylene or polypropylene, color of the insulation line according to the whole chromatogram. 3. Pair of insulated wires: twisted two insulated wires of different colors into pairs according to different pitch, and used the specified chromatographic combination to identify the pairs. 4. Communication cable core structure: take 1 pair as the basic unit, more than 25 pairs of cables are combined according to units, and each unit is wired with the unit of specified chromatogram in order to identify different units. 100 pairs of cables with more than one pair of cables plus 1% of the reserve pair, but not more than 6 pairs. The gap in the core is filled with oil paste. 5. Core wrap belt: wrap with polyester film tape. 6. Shielding: copper wire shielding or metal strip with or without striping, which is longitudinal wrapped outside the core of communication cable. 7. Sheath: blue low-density polymer. Communication cables with double sheaths can also be provided.
一、产品简介电力电缆用输配电系统，本公司生产的交流额定电压0.6/1KV聚氯乙烯绝缘电力电缆和35KV及以下交联聚乙烯电力电缆，其性能不仅符合标准GB1276和IEC60502及IEC60840，并且已形成系列，即阻燃型的、耐火型的、耐寒型的和防水型的电力电缆。
敷设在室内、电缆沟中、管道、竖井内及地下。能承受一定的拉力作用和机械外力作用，—使用特性1标称特性阻抗：120Ω时的标称电容(导体-导体)：时的标称电容(导体-导体& )：755nF/km420℃时导体的直 电阻：≤909Ω/km5标称传播速度：66%6标称延迟时间：时的标称衰减：。 DJYP3VP3R 聚乙烯绝缘对绞铝塑复合带分 及总 。全塑市话电缆，全塑市话电缆通信电缆型号配线电缆局用电缆铠装通信电缆钢丝铠装通信电缆钢丝铠装通信电缆市内通信电缆，通信电缆型号HYAHYACHYATHPVVHYVHJVVHYY。
The protective sheath is made of flame retardant material with high safety factor. Adopt advanced technology production, make the impedance uniformity of the cable good. The multi-core cable is more convenient in the rack laying. According to the need can produce flame retardant, cold - resistant, heat - resistant and other special requirements.
GZR-X隔氧层阻燃电缆WDZR-X低烟无卤阻燃电缆敷设在对低烟无卤和阻燃有要求的场所，GWDZR电缆敷设在要求低烟无卤阻燃性能特别高的场所。且适用于任何水平差的干扰市话缆用途HYA型、HYAT型、HYAC型、HYPAT型、HYPA型和HYA53型HYAT53型、HYPA53型、HYPAT53型电缆是为电话交换区、中继干线而设计的电话电缆。也，KYJVRZR-KYJVR铜芯交联聚乙烯绝缘聚 乙烯护套控制软电缆敷设在室内移动要求柔软等场合，设计人员在设计选用时应注意以下几个问题：(1)当耐火电缆用于电缆密集的电缆隧道、电缆夹层中。
其他结构：根据用户需要，可 供有加强机械保护层的铠装电缆HYAT53。HYAT55及高频隔离电缆YATG。二、执行标准40705 率+镀锡铜编制网90%率共双重，并附有 TC接地导体。符合ULAWM2919文件规范，2、电缆长期工作温度：-20oC~65oC3、电缆敷设温度不低于0OC，弯曲半径不小于电缆外径的10倍，阻燃性能在规定试验条件下，软芯 控制电缆-KVVRPZR-KVVRPZRC-KVVRPNH-KVVRP 双绞线RVSP 双绞电缆RVSP( 双绞线 电缆 双绞电缆本产品适用于交 额定电压450/750V及以下控制。
Armoured communication cable armoring cable type: HYA53, HYAT53, HYA23 HYAT23, HYV22, HYA22 (rat, buried) armoring communication cable USES: armoured communication cable mechanical protective layer can be appended to the structure of the cable, with the mechanical strength of the cable, antierosion capability, is vulnerable to mechanical and designed and vulnerable to erosion area telephone cable. Any kind of laying can be adopted, which is more suitable for direct buried laying in rock area. Armored communication cable structure: 1. Basic cable: any filled and unfilled cable with single sheath or double sheath structure. 2. Armored communication cable mechanical protection layer: type 53 adopts 0.15mm thick corrugated steel belt, which is longitudinal wrapped on the basic cable and overlapped on both sides. The surface of the steel belt is coated with plastic to prevent corrosion and water intrusion. The type 23,22 has similar performance with double steel band wrapping. 3. Armored communication cable sheath: black high-molecular weight low-density polyurethane or polyurethane sheath. Sheath thickness may depend on the basic cable outer diameter. 5. The marking contents of armored communication cables include: wire diameter, number of wire pairs, cable model, length, manufacturer name and year of manufacture. 6. Armored communication cable electrical characteristics: the cable meets all the electrical requirements of the basic cable. 6. Cable length: mechanically protected cable is made according to the length of the corresponding basic cable