EN50636-2-100图2成人手臂试具碎屑收集器弯曲通道稳定性和机械危险运动部件试验
成人手臂试具符合IEC 62841-4-6:2022图105、EN50636-2-100图2标准要求
对于弯曲的通道，危险的运动部件不得通过任何手臂试具触及
当将每个手臂试具插入到每个手臂的整个长度的开口中时，每个手臂试具不得与危险的运动部件接触。每个试具的铰接件应能绕铰接轴旋转±90°。每个试具的运动应足够自由，以不超过20 N的力。
每个手臂试具在接近危险运动部件时，应在关节允许的任意方向上进行扭转和移动。必要时，可切除机器的一个或多个部件，使试具能够调整姿态，尽可能向危险运动部件伸入。切除部件后，试具的伸入深度不得超过切除前的水平。
The impeller or shrddding means, if any, shall not be accessible by means of any of the arm probes, for any operating configuration
Compliance is checked by inspection, by measurement and, if applicable,by the following test.
Piror to conducting the test, the debris collector and all detachable parts are removed from the machine, unless they comply with the de-energizing requirements of the impeller or shredding
The arm probes shall not contact the impeller or shredding means, if any, when they are inserted, in turn,into any
- blower tube; or
- vacuum tube; or
-debris collector tube
两支手臂试具均不得接触危险运动部件。在碎屑收集器就位的情况下进行测试时，不得将碎屑收集器的任何部件推入危险运动部件中。
