YFFBGP/3*35+2扁电缆

 一、安全工具应由安全员负责，每月月底对安全工具认真检查一次，并做好记录；安全工具应编号放在固定地点，不得乱拿乱放。YFFBGP/3*35+2扁电缆

1. Safety tools should be carefully inspected and recorded by the security personnel at the end of each month. Safety tools should be numbered in a fixed place and should not be randomly placed.

二、安全工具要定期试验，每年按规定周期进行试验。

Two. Safety tools should be tested regularly and tested every year according to the prescribed cycle.

三、安全工具要妥善保管，经常保持干燥清洁，完整无损。严禁将绝缘靴、雨靴挪做它用，对已损坏的安全工具必须报废，撤出现场，禁止使用。

Three, safety tools should be kept properly, often kept dry and clean, intact. It is strictly forbidden to use insulating boots and raining boots for other purposes. Damaged safety tools must be scrapped, withdrawn from the scene and prohibited from use.

四、高电压等级的绝缘工具（操作杆）可用于低电压等级设备上使用，低电压等级的绝缘工具（操作杆）严禁在高压设备上使用，试电笔只能在同电压等级设备上使用。YFFBGP/3*35+2扁电缆

4. High-voltage insulation tools (lever) can be used in low-voltage e, low-voltage insulation tools (lever) is strictly prohibited in high-voltage e, test pen can only be used in the same voltage e.

五、使用安全工具时要爱护，要检查，交接班时要检查安全工具是否完全，存放是否整齐。

5. When using safety tools, we should take care of them, check them, check whether they are complete and keep them neatly.

六、对新增安全器具应做好登记记录。

Six, registration of new safety appliances should be done well.

八、已到报废的或不合格者安全器具应立即收回，并上缴做记录。YFFBGP/3*35+2扁电缆

Eight, the safety appliances that have been scrapped or un should be recovered immediately and turned over to record.

九、做好对各种标示牌、警告牌、语言警告牌、网状遮栏的归类整理，登记工作。

9. Do a good job in sorting out and registering all kinds of signs, warning signs, language warning signs and mesh barriers.

十、已经试验好的安全工具要统计、登记并填写好试验周期表，一式两份，现场即安全工具室墙壁贴一份，另一份连同试验报告存入档案。

10. The safety tools that have been tested should be counted, registered and filled out the test periodic table in duplicate. One copy is affixed to the wall of the safety tool room on the spot, and the other is stored in the file together with the test report.

十一、安全器具室的干燥灯要每周检查一次，阴雨天气应将灯打开保持干燥，同时每周应对安全工具进行清扫一次保持整洁。

11. The dry lamp in the safety apparatus room should be checked once a week. The lamp should be turned on and kept dry in rainy weather, and the safety tools should be cleaned once a week to keep clean.